The following is a list of frequently asked questions about the BOB ROSS Oil Painting Technique and some instruction about the use and care of the materials.

BLENDING:

This technique refers to the softening of hard edges and most visible brush strokes by blending the wet oil paint on the canvas with a clean, dry brush. In blending, an already painted area is brushed very lightly with criss-cross strokes or by gently tapping with the corner of the brush. This gives colors a soft and natural appearance. Not all oil paints are suitable for this technique – most are too soft and tend to smear. Only a thick, firm paint is suitable for this technique.

MARBLING:

To mix paints to a marbled effect, place the different colored paints on the mixing area of your palette and use your palette knife to pick up and fold the paints together, then pull flat. Streaks of each color should be visible in the mixture. Do not over mix.

THINNING PAINTS FOR ADDING HIGHLIGHTS:

When mixing paints for application over thicker paints already on the canvas, especially when adding highlight colors, thin the paint with LIQUID WHITE, LIQUID CLEAR or ODORLESS THINNER. The rule to remember here is that a thin paint will stick to a thicker paint.

CLEANING AND DRYING THE BRUSHES:

Painting with the wet on wet technique requires frequent and thorough cleaning of your brushes with paint thinner. An empty one pound coffee can is ideal to hold the thinner, or use any container approximately 5″ in diameter and at-least 6″ deep. Place a Bob Ross Screen in the bottom of the can and fill with odorless thinner approximately 1″ above the screen. Scrub the brushes bristles against the screen to remove paint sediments which will settle on the bottom of the can.

Dry your larger brushes by carefully squeezing them against the inside of the coffee can, then slapping the bristles against a brush beater rack mounted inside of a tall kitchen trash basket to remove the remainder of the thinner. Smaller brushes can be cleaned by wiping them with paper towel or a rag (I highly recommend using Viva paper towels because they are very absorbent). Do not return the brushes to their plastic bags after use, this will cause the bristles to become limp. Never clean your Bob Ross brushes with soap and water or detergent as this will destroy the natural strength of the bristles. Store your brushes with bristles up or lying flat.

APPLYING LIQUID WHITE:

Use the 2″ brush with long, firm vertical and horizontal strokes across the canvas. The coat of Liquid WHITE should be very, very thin and even. Apply just before you begin to paint. Do not allow the paint to dry before you begin.

PLACEMENT OF OIL COLORS ON THE PALETTE:

I suggest using a palette at least 16″x20″ in size. Try arranging the colors around the outer edge of your palette from light to dark. Leave the center of the palette for mixing your paints.

LOADING YOUR BRUSH:

To fully load the inside bristles of your brush first hold it perpendicular to the palette and work the bristles into the pile of paint. Then holding the brush at a 45 degree angle, drag the brush across your palette and away from the pile of paint. Flipping your brush from side to side will insure both sides will be loaded evenly.

(NOTE: When the bristles come to a chiseled or sharp flat edge, the brush is loaded correctly.)

For some strokes you may want the end of your brush to be rounded. To do this, stand the brush vertically on the palette. Firmly pull toward you working the brush in one direction. Lift off the palette with each stroke. This will tend to round off the end of the brush, paint with the rounded end up.

MIXING FOR HIGHLIGHTS:

Place the tip of your brush into the can of LIQUID WHITE, LIQUID CLEAR or ODORLESS THINNER allow only a small amount of medium to remain on the bristles. Load your brush by gently dragging it through the highlight colors, repeat as needed. Gently tap the bristles against the palette just enough to open up the bristles and loosen the paint.

LOADING THE PALETTE KNIFE:

With your palette knife, pull the mixture of paint in a thin layer down across the palette. Holding your knife in a straight upward position, pull the long working edge of your knife diagonally across the paint. This will create a roll of paint on your knife.

WHAT IF I HAVE NEVER PAINTED BEFORE?

There are no great mysteries to painting. You need only the desire, a few basic techniques and a little practice. lf you are new to this technique, I strongly suggest that you read the entire section on “TIPS AND TECHNIQUES” prior to starting your first painting. Consider each painting you create as a learning experience. Add your own special touch and ideas to each painting you do and your confidence as well as your ability will increase at an unbelievable rate.

WHAT PAINT SHOULD I USE?

The BOB ROSS technique of painting is dependent upon a special firm oil paint for the base colors. Colors that are used primarily for highlights (Yellows) are manufactured to a thinner consistency for easier mixing and application. The use of proper equipment helps assure the best possible results.

Liquid Clear is a particularly exciting ingredient for wet-on-wet painting. Like Liquid White/Black, it creates the necessary smooth and slippery surface. Additionally, Liquid Clear has the advantage of not diluting the intensity of other colors especially the darks which are so important in painting seascapes. Remember to apply Liquid Clear very sparingly! The tendency is to apply larger amounts than necessary because it is so difficult to see.

13 colors we use are listed below:

*Alizarin Crimson

*Sap Green, Bright Red

*Dark Sienna

*Pthalo Green

Cadmium Yellow

Titanium White,

*Pthalo Blue,

*Indian Yellow

*Van Dyke

Brown

*Midnight Black

Yellow Ochre

*Prussian Blue
(*indicates colors that are transparent or semi-transparent and which may be used as under paints where transparency is required.)

HOW DO I MIX COLORS?

The mixing of colors can be one of the most rewarding and fun parts of painting, but may also be one of the most feared procedures. Devote some time to mixing various color combinations and become familiar with the basic color mixtures. Study the colors in nature and practice duplicating the colors you see around you each day. Within a very short time you will be so comfortable mixing colors that you will look forward to each painting as a new challenge.

SHOULD YOU USE JUST ANY ART PRODUCT FOR THIS METHOD OF PAINTING?

Possibly the #1 problem experienced by individuals when first attempting this technique and the major cause for disappointment revolves around the use of products designed for other styles of painting or materials not designed for artwork at all (i.e. house painting brushes, thin soupy paints, etc.).

All of the paintings for this technique were created using Bob Ross paints, brushes and palette knives. To achieve the best results from your efforts, I strongly recommend that you use only products designed specifically for use with the Bob Ross wet-on-wet technique.

HOW LONG WILL IT TAKE MY PAINTING TO DRY?

Drying time will vary depending on numerous factors such as heat, humidity, thickness of paint, painting surface, brand of paint used, mediums used with the paint, etc. Another factor is the individual colors used. Different colors have different drying times (i.e., normally Blue will dry very fast while colors like Red, White and Yellow are very slow drying). A good average time for an oil painting to dry, when painted in this technique, is approximately one week.

SHOULD I VARNISH MY PAINTINGS?

Varnishing a painting will protect it from the elements. It will also help to keep the colors more vibrant. lf you decide to varnish your painting, I suggested that you wait at least six months. It takes this long for an oil painting to be completely cured. Use a good quality, non-yellowing picture varnish spray. I personally spray my paintings after about 4 weeks and have not had any problems.



Source by Gerald Scott